The stringing you see is just remnants of the support I was using

Maker Select 3D
PLA 1.75mm
.4mm nozzle
.20mm layer height
.8mm shell thickness
1.2mm Bottom/top thickness
10% fill density
75mm/sec print speed
200C Print temp
70C bed temp

I've taken a dial indicator to the bed and in the middle it bows down about .003" vs. the edges but I doubt that's an issue.

2017-02-26 16.06.23.jpg2017-02-26 15.20.56.jpg2017-02-26 15.20.50.jpg

Thanks for any input guys.

Davae