Results 1 to 1 of 1
-
12-13-2016, 10:23 PM #1
- Join Date
- Dec 2016
- Posts
- 1
Homing Z outside of inductive sensor range...
I have an issue where Z does not home in the middle of the bed. When homing all axis, X & Y go to 0 but then Z starts to descend at X0 Y0 and crashes the hot end since the probe is off the bed. If I fake it by tripping the probe manually, it then moves to the center to "rehome" Z. I cannot find where in the config to tell it to stop trying to home Z at X0 Y0 first. Any ideas? Using a i3 clone with marlin.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion