Ok, one of the most innovative 3D printers I saw at the Inside 3D Printing Conference had to be the mcor technologies printers. They don't print using any traditional 3D printing methods. They have come up with their own patented technology which actually bonds stacks of 20lb printer paper (yes your traditional 2D printer paper) together, using an adhesive. It also lays down a layer of ink for each piece of paper in the stack (if applicable). It then uses a cutting tool to cut the design out of the paper. The results? They are quite amazing. The quality of the prints are as good, if not better that those done on some of the high end SLA and SLA printers. Check out some of the photographs that we took this week:






These printers are quite expensive though. Not something the typical person will be able to buy and keep in their garage.