Bad Builds-Makerbot 2X {Using Supports and Rafts}

[Spychris101]

Ok when i try to print something it doesnt come out good I have Pictures. If you don't see the Pictures, Here is a Link to a URL to the Pictures: HERE IS THE NEW LINK: https://plus.google.com/104715717875...ts/KGUhUGwo3GU

[curious aardvark]

link doesn't show me pictures either.

404. That’s an error.
The requested URL was not found on this server. That’s all we know.

[Spychris101]

link doesn't show me pictures either.

Here is the New Link: https://plus.google.com/104715717875...ts/KGUhUGwo3GU

[curious aardvark]

yep that's horrible alright :-)

So, the usual: what slicer are you using, what filament: type and make, are you using, what temperature, speed, extrusion etc settings are you using.

The more information you give us, the better the chance we can work out what's going wrong :-)

[Spychris101]

yep that's horrible alright :-)

So, the usual: what slicer are you using, what filament: type and make, are you using, what temperature, speed, extrusion etc settings are you using.

The more information you give us, the better the chance we can work out what's going wrong :-)

I am using ABS, The Temperature is Set at 230, Platform Temp is Set at 125, I am using Kapton Tape for the Build Plate, and the Travel Speed is set at 150 mm/s

[curious aardvark]

print speed ?
I usually set my travel speed to be the same as my print speed, saves sudden acceleration that pulls up little spikes of plastic.

platform temp should be 90-100
doesn't need to be hotter.

What make of abs, what slicer.
The bit about LOTS of information was important :-)

[Spychris101]

print speed ?
I usually set my travel speed to be the same as my print speed, saves sudden acceleration that pulls up little spikes of plastic.

platform temp should be 90-100
doesn't need to be hotter.

What make of abs, what slicer.
The bit about LOTS of information was important :-)

You mean the Brand of ABS? When i use any type of ABS it doesnt work. I don't know what a Slicer is