Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 03-31-2016, 04:52 PM #1
    kd7eir
    kd7eir is offline
    Technologist
    Join Date
    Oct 2014
    Posts
    134

    Odd print behavior

    I am at a loss to figure this out. I use ABL, verified that the Z offset is correct. Nothing has changed in S3D settings, same roll of filament as my last successful print.

    DSC_0001.jpg
    Reply With Quote Reply With Quote
  2. 03-31-2016, 08:20 PM #2
    Roxy
    Roxy is offline
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    It does look like you are a little bit too far off of the bed. And you may need more hair spray in the middle.
    Reply With Quote Reply With Quote
  3. 04-01-2016, 08:20 PM #3
    kd7eir
    kd7eir is offline
    Technologist
    Join Date
    Oct 2014
    Posts
    134
    Quote Originally Posted by Roxy View Post
    It does look like you are a little bit too far off of the bed. And you may need more hair spray in the middle.
    In spite of being sure of my measurements, I took your advice and added .1 to my Z offset, and now it's printing perfectly. Thank you.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules