my stupid instructions say , to use (g1 x0 y66 z10) (g1 x-57 y-33 z10) (x57 y-33 z10) use the paper tension method , and right down where i have contact , then adjust screws until i succesfully get them all to match. Which i have done. Then it says to check the Zm which it says use (g1 z10) again use paper tension method and it should match the other 3. if not to change the smooth rod offset. well nothing changes after i change it , the Zm never matches up. It stays at .20 off

At this point , it seems like the nozzle will dig in in the middle. I can share my instructions , code , w/e to help me figure this out