Hi team, new to the forum, just received my Mod-T ... had a little bit of trouble getting it set up but I've printed a test print (the New Matter logo) and I'm now printing a phone stand from the New Matter store.

This is my first 3D printer experience and I have to say I am very impressed so far. The packaging was excellent ... as was the included card directing me to unpacking. I wasn't aware that I would have to connect to a computer to complete the initial setup, but I understand that in order to configure wifi I would need to connect.

The only issue I've seen thus far was during the installation / setup. When I got to the end and the installer asked me if I wanted to try a test print, I said sure, and the print head lowered to the tray and then errored. I tried again, same. So I ended the installer and then tried again from the mod-t printer tool application and it was able to start and complete.

I'm looking forward to seeing / hearing what others' experiences are ...

-greg