I have a PowerSpec 3DPro and I'm using the inland Filament from Microcenter.

Lately, I'm having some Print quality issues. initially, I had concerns that my Build plate wasn't level, so I bought a glass build plate. I now have it leveled the best I can get it.

I have both ReplicatorG and Simplyfy3D - I'm actually getting significantly worse prints with S3D, so I've really just been sticking to ReplicatorG for the time being. It doesn't matter what I do, I just can't seem to get a print without some type of blob, defect, etc. I've tried printing slow, quick, etc.

I've attached a picture of a print I just did. Tips and suggestions are highly welcomed.
This is at:
.12 Layer Height
10% infill
1 # of shells
30 Feedrate (I've gone up to 55 with no change)
40 Travel Feedrate (I've gone up to 85 with no change)
ABS @ 240C (I gone down to 230 and it made no difference)