The Ein Scan website says that resolution down to 0.1mm are possible. Well .. I donno about that. I believe that Nerv reported scans picking up embossing 0.2mm in height.

So. Trying to scan this figure. It is approximately 4 in. tall. I sprayed it with a white primer and used a dark wash to try and see if that would help. I tried five scans. One with the figure on the turntable .. and four more with a block under the model so it tilted forward .. with all 4-axises raised and scanned (titled forward, backward, left and right). This was all done in hi-res.

scanning.jpg

Here's a close-up of the front of the figure to show what is being scanned.
cokeGuy.jpg

and here is the result. Really soft.


snapshot00.jpg

sooo .. suggestions to increase the detail? This was scanned with the overhead lights off so room was fairly dark .. just some light from windows ... not too much of that.
I