Hardware feature requests

[24c]

Hi,

A few early adopters have made software requests, but I thought a thread on hardware requests might be a good idea.

Just a thought, but would it be possible to incorporate an adaptor to take a standard tripod screw, so that's 1/4" UNC, in the base of the scanner in future?
I'll be making a quick release adaptor plate in the future for my scanner, but long term I think it would be useful to be able to simply release the scanner from its calibration/turntable mode without having to undo screws.

Mike

PS Have a design freebie.
Why don't you make some fold down legs (or three support tubes screw in to the perimeter areas) to act as a table to support the scanner in calibration mode? A change to your template is all that is needed, and it would free the middle of the scanner up for tripod fixing.