Hey everyone,

I was trying to load a new filament into my right extruder of my FFCP and encountered a problem. I had very little filament left on the old spool so I tried to unload it but got a strange issue where I couldn't pull the filament out and it started clicking/jamming. So I snipped the filament, hoping to just push it through with the next filament. Well, I pushed most of it through but not all--the new filament never started extruding out the bottom, and the motor started clicking again before all the old filament could be pushed through. It seems like the filament is just getting jammed inside there somehow and the motor is trying to feed it through but just slipping instead, making that noise.

I'm sure others have encountered similar problems--any ideas on what to do?