Z18 limit to small prints

[MANICX100]

Hi all,

Does anyone have experience with small (<50mm) prints at good quality on a Z18 as parts only come out correctly at larger sizes. Often stringing on the base.

• 0.15mm resolution
  
• 5th Gen High Base
  
• 200 °
  
  
  • Lower to 180 ° on Color Fabb to stop raft stick
  
  
• Roof layer count 4
  
• Shells 2
  
• Outlines 15
  
  For moving parts I change:
  
• "feedDiameter": 1.80,
  
• "feedstockMultiplier": 1.10 on small parts doesn't work tried higher values but too many holes in prints

[sinful]

Hi,

Z18 is designed for bigger prints and the quality is also great. Do you have a lot of retractions of the small parts? Have you tried using Dust filter, it can reduce the stringing and increase the quality of the parts.