Results 1 to 8 of 8
Thread: Weird issue with ABL Z probe : S
Threaded View
-
03-23-2015, 09:02 AM #1
Weird issue with ABL Z probe : S
Hello all,
I recently installed Auto Bed Levelling on my Makerfarm i3v and I noticed the Z probe starts shaking when the Z axis is moving. Today it started shaking a whole lot and then the print just stopped, the LCD done like a refresh and that was it. I tried printing again and about 10 minutes in it happened again. I then unplugged the servo and the print made it all the way through (7 hours).
Anyone have any idea how I could fix this problem?
Cheers.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion