When Mike at DIY AQUAPROS decided one of their aquariums needed a new CO2 diffuser, he wasn't shy at all about diving right into Tinkercad and using one of the 3D printers at his university to 3D print out a newly designed CO2 diffuser, which was a success in its basic design. While it was fully functioning on his first try and put right into use, Mike mentioned that he would make the diameter thinner next time by a couple of centimeters, and refine the size of the lid. Find out more about this project in the full article: http://3dprint.com/46766/diy-aquapros-3d-printed/


Below is a photo of DIY AQUAPROS' 3D printed CO2 diffuser: