Hello everyone. I am new to the arena and the forum. I have been reading everything I can to get better. I am trying to figure out what would cause the terrible quality print that you see in the photos below.

I am running:
Flash Forge Creator Pro
7.7 Sailfish Firmware
Replicator G Sailfish
Blue PLA 1.75mm included with printer
Bed temp 35C with blue painter tape
Nozzle Temp 230C
80mm/s feed
100mm/s travel
Open enclosure
Printer is in an empty room with a ceiling fan on

The weird thing is that when I run the gcode I set my nozzle temps to 200 but when it starts printing it goes to 230. I have to use the printer to lower the temps if I need to. I am not sure if the feed and travel rate changes because I'm printing off the SD card. I have too many issues trying to print from my laptop. ANY advice for anything 3d printing related I will take on board and become better. Thank you.