Please help me ! i have problem with Bed Leveling.

[Jimmy143]

Hello everyone.

I'm new on 3D printing .. and i just install my Aurora Reprap Prusa I3. but i face alot of problem to fix..

my bed leveling is so bad. and i can't pring in the center the extruder start from left or right. and i can't see where is the problm.

please i need help to solve this problem.

i need to start calibrate it to be printing in the center.

[Roxy]

What does 'Pring' mean? What does it do correctly? What is the first thing that happens that you know is wrong?

[Jimmy143]

What does 'Pring' mean? What does it do correctly? What is the first thing that happens that you know is wrong?

oh sorry it mean Print * I feel there is problem with Bed leveling. because when i print cube for test there is too much damage on it.. something wrong with it..

but this is not the big problem.. the problem when i put item in center with Cura program he print in left side and sometime outside the Bed.

[Roxy]

I don't know anything about Cura, but others here use it a lot. With that said, I can help you with the Auto Bed Leveling.

[Mils24]

I would also like info on bed levelling a delta as I am having horrible bed levelling issues with my new delta kit. Do you know of any step by step guides for a total newbie for installing and setting up auto calibration on a delta using Repetier firmware?

Thanks

[Roxy]

I wish I had a Delta... but I don't. Those are a little bit tougher, but somebody that has gone through the experience will be able to help you better. Almost for sure one of those people is going to be willing to jump in.