Search:

I've got the RAMPS with a standard LCD. For the moment, I've changed the EXTRUDE_MINTEMP value to work with the wax.

Both of those options are a bit beyond my ability at the moment, as I'm not sure how to do either of them. Not that I don't understand.

Option #1 sounds like it would require that I reprogram...

So I've been able to make several good prints at this point, again, thanks to everyone for helping!


Where I'm at now, I'm trying to print with some wax material (for use with investment...

So I've noticed a new issue, but I think I should start out with some good news.

http://i571.photobucket.com/albums/ss151/styxm18/3d%20prints/WP_20160418_11_07_15_Pro_zpseuughhjm.jpg

The one...

Well, that was fun, the cartridge heater failed 7 hours into a print. I managed to otherwise get a non-warped PETG print though.

Ok, here are some of the pictures.

First print(s), the cube was with the slic3r profile, and the robot was with Cura....

Hi!

I didn't see an introduction thread anywhere, and only just found this forum so haven't had a chance to really search everything, so bear with me.

I bought, assembled, and have been running...