This.
People who want a gun, are going to get a gun. Is 3D printing another outlet? Sure, it may be.
However, you can build a much better, more reliable, more accurate gun that has the same...
Type: Posts; User: laneinator
This.
People who want a gun, are going to get a gun. Is 3D printing another outlet? Sure, it may be.
However, you can build a much better, more reliable, more accurate gun that has the same...
Does it actually reach operating temperature? The unused extruder will heat up due to heat from the extruder and bed right next to it. Mine might see temps of around 60-70 degC just because of heat...
Glad you got it resolved!
Its possible, but you're also trying to feed the filament at the same rate the printer is feeding it. That might be causing the difference in the filament diameter coming out.
Did you try and...
Lol, sorry.. Had to.
When the right extruder reaches temp, do you hear the motor TRYING to pull the filament in? If you cant tell, you should take the stepper motor off the extruder bar and run the loading sequence. You...
Do you have the filament guide tubes attached straight to the back of the printer? I had this problem also. The filament got caught up in the spool holder and the motor on the extruder couldn't pull...
I ended up uninstalling and reinstalling makerware and everything is good to go now, I'm not sure what the initial deal was.
I was still confused/thought there was an issue at first though. The...
So apparently my printer will accept .x3g files from ReplicatorG but not from Makerware
I have not yet tried that. I will give that a shot tonight when I get home. I'm also going to try and open the .x3g in a notepad (not sure if it'll let me) and compare it to the test parts that my...
I'll be getting a card reader tonight to see if that fixes it.
For the makerware I specified the replicator 2 dual I think. I just made sure it exported the .x3g file.
A little searching and some people are saying the older sailfish 7.7 says CreatorX but was used on both X and Pro. The new 7.7 says CreatorX/Pro. I'm thinking this not the reason my printer isn't...
So the printer I got was an amazon return sold on ebay 'for parts,' this was just how I got it. I haven't installed anything to the printer but judging by your reaction, I have a problem..
UPDATE: The right extruder heating element had a bad crimp on the motherboard end of the wire, so it wasn't attached.
So now its just a matter of getting the printer to recognize the .x3g files...
Hey guys,
So I just got my FlashForge Creator Pro and I'm having 2 issues.
The first problem is the right extruder does not heat up. It gives me an error message:
Tool 0 Failure! Not heating...