Search:

this was printed with skeinforge
setting set at
15% infill
.25 layer height
2 shells
40 feedrate
60 travel
195 temp....

I am super new to 3d printing and have in total 25 hours experience...

Oh crap I didnt even realize that didnt say 3d printing woops sorry for the mixup ill post it on the 3d print forum

this was printed with skeinforge
setting set at
15% infill
.25 layer height
2 shells
40 feedrate
60 travel
195 temp

I got it dialed in now at 50mm/s thanks for the help

Right now I am printing at 15% infill .3 layer height 2 shells 65mm/s feedrate 90 travel 205 temp I cleared the nozzle changed filaments tighten tension on filament the spool turns freely with...

Ok so I tried everything suggested but I am still getting clicking sounds and bad prints...I also tried changing the filament which improved it a lot but it still clicks and slips but not as...

I have clear the nozzle, printed at higher temp, and tried tightened the tension screw for the filament

so when I print I am getting filament slippage and I know its that due to clicking and when it clicks I can fell it in the filament also when it clicks I can see it stop extruding for a split...

Okay so I got it working pretty amazing now.I leveled the bed, manually fed PLA through the nozzle to clear it, then I unloaded and reloaded the filament the I went from 205°C temp to 215°C and now...

I watch a print very closely and I am definitely have filament slippage because as I watch with every click sound I can see the extruder momentarily stop extruding and then continue leaving the gaps...

yes I am printing PLA and yes there is a clicking noise (it sounds like slipping filament) plus when printing also my filament measures out to 1.61mm and my gcode was set to 1.82mm I dropped it down...

when I print my solid layers have gaps. see pic
setting for print
infill %10
layer height .27mm
shells 1
feedrate 100mm/s
travel 120
temp 205
what will make solid aesthetically pleasing layers