Sounds like a clog or to low of a temperature. Make sure your temp sensor is not working its way out of the extruder.
edit...
Also check your extruder stepper current limiting. Also check your...
Type: Posts; User: Donziboy2
Sounds like a clog or to low of a temperature. Make sure your temp sensor is not working its way out of the extruder.
edit...
Also check your extruder stepper current limiting. Also check your...
Ya I kinda looked at that when I was having lots of z-wobble(was an over-tight thread in the tubing that was forcing the screw to one side). The metal frame does not appear to move much if any...
I have had this happen and I think its caused by the spool binding just long enough for the gear to chew into the filament. I plan to work on my spool holder at some point, I replaced the wood part...
ABS seems to be the hardest material to get right sometimes, I have had some prints come out flawless and then larger prints just refuse to stay stuck. I am still working on getting ABS to behave. ...
It shows the output I can look when I get home.
We are talking about the manual controls. If your trying to extrude with a cold hotend with everything assembled then you deserve to have to clean up a mess.
I had no problems running the extruder with pronterface while the hotend was cold.
Yep Plexi.
Are you using Makerfarm Marlin or did you download it from somewhere else?
edit..
I don't recall doing anything with eSteps on my printer lol.
Check your current limit on your stepper driver. If its to low it wont be able to move. Also when you start making your own slicer configs be careful not to set the stepper speed to high for...
What happens is that there is some play in the threading of the nut so you can get a small amount of movement, depending on the nut and rod that could be enough movement to cause gaps during...
Flatty, I hope you did not drill out the Z-rod traps to much, to much play will cause backlash issues.
Also be careful of over screwing/tightening the rods into the tubing, I actually had issues...
Flatty did you get your pegasus assembled?
I did a few test prints over the weekend, first 3 came out pretty good, last one ran overnight and looks like the bed moved up/down twice during heating. ...
Im using adapters.
Im just ahead of ya:) Got mine 2 weeks ago, had a smashed finger so I waited for it to heal up enough to not hurt every time I moved it. Been working on mine since Friday morning, doing a little...