Hello Bob, Any chance you have rounded up your files and can post them for others to use?
~James
Type: Posts; User: jlhR2
Hello Bob, Any chance you have rounded up your files and can post them for others to use?
~James
Thanks Dustin,
Yes I did define the number of servos to 1, pretty sure I defined the z endstop as a servo, and yes I set the angles. Someone did point out to me today one possible issue is that I...
Why dont you just get yourself a sheet of 300mm x 300mm x3mm borosilicate glass, and then buy a glass cutter and cut of the 80mm each side to fit?
Glass cutting is super easy, just get a very...
okay (good news, bad news)x2 =
Good news1 = I uploaded the file and it worked, I have servo control.
Bad news1 = M401/M402 didn't work, and when I tried to check the G29 ABL program, nada. It...
Woohoo, it compiled. Thanks for the help Dustin. If I should have any further comments or questions on my ABL I will address them here on this thread.
James
A Suggestion to correct the problem is to change all of the above code in pins.h to the following
//#define SERVO0_PIN 5 //Less the " // "
Does anyone else concur? or got any other ideas? I...
arduino IDE you mean the arduino application, and I get the latest marlin firmware from the reprap.org forum?
I am trying to follow the Zennmaster tutorial on setting up ABL, BUT... Ihave hit a snag as his instructions follow the RAMPS board and I have the RUMBA.
Now I have googled and searched the forum...