Does this if I print via usb, or SD card. Often when I am sending to printer using "Cached" it will freeze during upload. I've swapped USB cables, tried different ports and most recently purchased...
Type: Posts; User: wingnut1000
Does this if I print via usb, or SD card. Often when I am sending to printer using "Cached" it will freeze during upload. I've swapped USB cables, tried different ports and most recently purchased...
Do any of these look like cold solder joints?
Having issues with my Ramps. Think it may be due to soldering. Small album here
Any of these look like cold solder joints? Issue is after a few prints, or print longer then 15 minutes or so,...
Your help is MUCH appreciated.
As I'm pulling a pretty heavy load working from home atm I can't do much troubleshooting. I can say that today I did a successful small test print (about 6 minutes)...
Thanks for the clarification. I tested using AC volt mode and it does indeed show 0V. Thought I was doing it wrong.
How would I avoid powering over USB. Don't think I have control over it. I...
Thanks for this. Heat up time has always been an issue but it has gotten worse, I'd say 20 min sounds about right, however I did not time it. Wires to RAMPS is 14 gauge stranded copper, to heated...
Old board appears to have damaged component, not just the run on the back. Don't think it would be easy to repair with my limited knowledge. I'm in the San Francisco bay area. No sign of damage on...
PSU troubleshooting
So I've been searching for help on various sources like reddit/r/3dprinting, reprap forums (which is down atm) and haven't gotten much help.
Printer: Prusa i3V 8"
First post
Purchased a Prusa...
Hey guys, I've been trying to get auto bed leveling working all day...
Running a Prusa i3v
Followed instructions in here for initial setup.
Got it working but was having the issue with the "Z...