Ok, so now it is working like it should.
I put a pull down resistor of 10k ohm 1/8w between the negative side of the thermocouple to the ground of th AD597 board.
My big mistake was to ground the...
Type: Posts; User: Goderfer
Ok, so now it is working like it should.
I put a pull down resistor of 10k ohm 1/8w between the negative side of the thermocouple to the ground of th AD597 board.
My big mistake was to ground the...
I'm with Repetier, but I assume that's the same thing.
I've already changed my voltage regulator for the l7805cv (5v output, 1.5amp, same max/min volt than the ams1117-5.0) since I burned the...
I found this : https://ultimaker.com/en/community/19184-no-more-error-mintemp-on-ultimaker-original-ad597-controller-problem-is-solved-totally
I'll try it soon
Hi everybody,
I've just throw out the melzi board on my Wanhao I3 for a ramps 1.4,
I also changed the thermistor for a thermocouple type K with the AD597, But I have strange reading.
It heat up...