I am back the jhead and so far no issues, if that keeps up then I know it was on the Hexagon side of things. I will swap it back in and kick up the print temp 5deg at time to see if that solves the...
Type: Posts; User: roybfr
I am back the jhead and so far no issues, if that keeps up then I know it was on the Hexagon side of things. I will swap it back in and kick up the print temp 5deg at time to see if that solves the...
Are you running PLA or ABS, and for what ever you run what do you use for temps?
Filement is 1.75 on both, in fact same exact spool. .40 noddle on both. After installing the Bulldog I reset the steps to what the bulldog recommended then did a calibration to make sure it was...
Is there teflon inside the Hexagon? According to MF site and other places it is all metal. The jam was not surprising see the issues others have had with this hot end. I noticed MF is going the E3D...
I recently switched form a Gregs/Jhead setup to a Bulldog Lite / Hexagon setup. After several prints I started getting jams/clicking from the extruder. The hobbed gear on the extruder was always...