I own a Monoprice Maker Select V2 and I recently bought MGChemicals Wood PLA Filament as well as a high-lubricity .6mm nozzle.
What settings should I use for the wood filament?
Type: Posts; User: Swiffi
I own a Monoprice Maker Select V2 and I recently bought MGChemicals Wood PLA Filament as well as a high-lubricity .6mm nozzle.
What settings should I use for the wood filament?
I just replaced the old ptfe tube since I experienced an awful clog. http://imgur.com/beTTUcD . The nozzle was surprisingly clean, but it is currently soaking in an acetone bath. Currently I replaced...
What do you mean by this?
I experienced what I assume is the same thing again. This time I was not able to pull it out. I took apart the extruder and that is not the issue, it was completely clean. The jam persists somewhere...
Yes, I heat it up to 215c before trying to remove any filament. I am getting a new nozzle soon, so I will do a deep clean then.
This has actually happened 3 times now but I thought I should get it checked out now. As I said, this usually occurs after a print is finished. I am never present for when the print is finished, but...
Unless it came stock without the tube, it came with a replacement tube and I read the instructions and there was no mention of placing the tube in. It was not a kit.
The right side of the filament. My extruder was jammed and I had to pull this out. This happened after a print finished.
I have a monoprice maker select v2 and have been printing for quite a while now. Just recently my printer started to do this. The filament used is AIO Robotics light blue. The print finished but...