Search:

Success !

Definitely overlapping at least 1/3 with the new scan area is helping a lot, as advised by Shining 3D in another thread.

I managed to free scan a part on my bike, about 400mm by...

Actually, it's not the scan that fails, but the alignment.

I can scan properly in free scan mode, the first scans comes out nicely, the second one as well, but when i ask the system to align them,...

That was tripod mode , both modes fail.

i powdered the part with talc, but unfortunately i don't see much progress.

6466

ok, i will try that tomorrow.

For my second part, i wanted to test an object with sharp edges and precise measurements, to be able then to measure the scanned dimensions .

But i'm running into trouble, i cannot get a clean...