Search:

Ok, I set the system up. I run a g28, then a g29. At that point is there anything else I need to do, or should I be ready to print? To be honest since I've had the autobed level I have only had 1...

I think I'm going to lose my mind. I'm getting no bed adhesion anymore. Since I went to the ABL I've had nothing but problems even printing. I printed better with Colin's Marlin firmware and the PITA...

Got it to work,hooray. I do have another question though.How do I get the servo to stop twitching? I enabled the deactivation delay with the standard number, and it twitches less. However it's...

Yeah, when I bring it down close to 0 it's accurate. I took that number and added it to my z offset and now it seems to work. Let's hope it sticks.

aggg, now it's trying to print mm above the bed instead of where I measured it. Bloody hell.

Roxy, that's what I'm using. From what I can tell it seems to be going to where I measured on the bed, but offset by the ABL amount I put into the firmware.

I downloaded the auto-bed leveling marlin firmware, with roxy's improvements. I have only changed the Servo angles numbers, and the measure offsets from the hot end.

When I perform a g28 the...

I was using the clough's excellent cooling system with the hexagon, but the e3dv6 is lower and it's cooling fan is in the way. Anyone have another version they use for cooling PLA?

Stupidity on my part. I was tightening it and snapped the shaft. I'm a moron like that.

My hot end bit the dust today. If I were to buy the e3d v6 what would I need to install it? I'm currently running with the improved hexagon cooling mount by clough42. I obviously can't print...

I had a long print going last night, and it was doing well. Then sometime in the early morning the filament became stripped, and it wasn't able to feed anymore. Now before I went to bed I slowed...