Search:

i have a printrbot simple 2014 the y axes has stopped working properly it jerks i have switched the x axes with it just to be sure but it still does not step right its an kysan1124103 its 42mm wide...

ok so for some reason the y axes moves in the down direction negative every new layer it started half way up a print that it was printing seen in one of the pic's any ideas as to why?


ok so i...

ok so I attached some pic's if you notice in the g-code the perimeter width is .4mm and infill/solid width is .67 this is wrong the infill width is the same as the perimeter width when I measure the...

thanks and yah the fan was not coming on when i printed it i got the fan running that helped a lot i just need to calibrate it because when i tell it to move 50mm on the x axes it moves 52.5mm

it worked thanks first print ever

ok thanks i lowered the temp as well 190c it was at 210c im using pla that slow it down alot i will give it a go

im using a printrbot simple and repetier host i think its a setting but my extruder keeps extruding before the print starts and makes a big mess all over the tip of the extruder
it sits about 5mm...