Your help is MUCH appreciated.
As I'm pulling a pretty heavy load working from home atm I can't do much troubleshooting. I can say that today I did a successful small test print (about 6 minutes)...
Type: Posts; User: wingnut1000
Your help is MUCH appreciated.
As I'm pulling a pretty heavy load working from home atm I can't do much troubleshooting. I can say that today I did a successful small test print (about 6 minutes)...
Thanks for the clarification. I tested using AC volt mode and it does indeed show 0V. Thought I was doing it wrong.
How would I avoid powering over USB. Don't think I have control over it. I...
Thanks for this. Heat up time has always been an issue but it has gotten worse, I'd say 20 min sounds about right, however I did not time it. Wires to RAMPS is 14 gauge stranded copper, to heated...
Old board appears to have damaged component, not just the run on the back. Don't think it would be easy to repair with my limited knowledge. I'm in the San Francisco bay area. No sign of damage on...
So I've been searching for help on various sources like reddit/r/3dprinting, reprap forums (which is down atm) and haven't gotten much help.
Printer: Prusa i3V 8"
First post
Purchased a Prusa...