Problem: The top layers are not fully covering the infill below, as a result the final top surface is not smooth, and the infill shadow can be clearly seen. Suggestions appreciated.
Machine -...
Type: Posts; User: TomH
Problem: The top layers are not fully covering the infill below, as a result the final top surface is not smooth, and the infill shadow can be clearly seen. Suggestions appreciated.
Machine -...
I am looking for a Hot End Vent Hood like a Satsana that will work with a CR Touch and a Direct Drive. The ones on Thingaverse won't work with an overhead Direct Drive and the posted Direct Drive...
I tried posting in Tips, Tricks and Help but got no help. Hopefully the General discussion Board will do better ... ... Aquila, now equipted with an Ender 3 Direct Drive Extruder/Hot End, using...
Aquila, now equipted with an Ender 3 Direct Drive Extruder/Hot End, using VoxelMaker and Cura slicers .... ... Initial Layer is GREAT, very smooth, sticks well ... 2nd Layer shows some rough spots...
Aquila, G32, Cura Slicer, Inland Filament PLA+, printing a large structure (at least large for me) about 200mm x 100mm base area. Initial layer works great, support stuctures outside base area look...
Thank you for your comments, they are taken to heart.
I am using Aquila, Cura, Jayo Filiment (White vs Black) ... Nozzle set at 200, Bed at 60 in all cases .... printing same flat item ... White Filament sticks most of the time while Black Filament...
Had the same issue .... need to raise the Y Limit Switch (left pillar at bottom) and then re-level.
Voxelab Aquila printrt in a very new users hands ......, that spells TROUBLE!Got the Bed Leveled ... all warmed up ready to go ... Select and Print and the extruder goes to approximately x 110, y220...