Well good new and bad news.
I was out with my friends and stopped by a local electronic shop and picked up a cheap 40mm fan for $1.00. It works perfectly! So I guess the first fan I bought is...
Type: Posts; User: BLKKROW
Well good new and bad news.
I was out with my friends and stopped by a local electronic shop and picked up a cheap 40mm fan for $1.00. It works perfectly! So I guess the first fan I bought is...
Don't worry your advice has not gone on deaf ears. I have been busying studying for school.
I got 20 mins to play with it today and I found which two wires are the black/red using your method....
The issue is the wires are all silver/clear so I had to look at the molex connector to guess which one is the red and black. I have already snipped the wires, is there anyway to test with a...
Yes that helps a lot! I am trying to connect a 3 pin 40mm fan. However, the fan had a 3pin to molex adapter and by using that I determined what cable is positive and which is negative. Could it be...
So I want to make sure before I start moving jumpers around. I took a photo of my Rumba Board:
http://i.imgur.com/y9wDNcm.jpg
So I am using FAN0 and I see in the red box there is a PWR section....
Any links on how to check the firmware to see if the fan is enabled? I am using the default one provided in the manual.
When I use the slider it turns the LED on Fan 0. I did notice two pins right...
So I have tried everything on FAN0 including moving the jumper for the 12V-Select. Any other ideas?
I was talking about the layer fan, I will trying again tonight and try to switch my pins around.
Thank you! I will try that tonight, is it possible to control the fan on machine control panel? There is a slider there that I cannot get to work.
So I have a dumb question, I have printed clough42's fan design and hooked up the fan to the Rumba board but I cannot get Simplfy3D to control it.
Do I have to update firmware or am I just stupid?