Search:

I have the same problem with wooden Y carriage warping, but after 20mins of heating - all ok. I think,this is due to the use of insulator made of cardboard.

I want to try aluminium Y carriage .
...

I print without any enclosure with no delamination

try to print at 270C

in any case

I'm not sure.
The fact that the printer worked fine last few months without any changes to the settings, firmware and mechanics.
Until yesterday, when it was trying to self-destruct raising Z up...

Before printing Z carriage was at the top, I did not pay attention and start printing. After warming, the Z carriage began to rise up to the top and was not able to move more. In that moment I turn...

http://www.npo-plastic.ru/catalog1/prutok_printer/

First, warping can be stopped by setting highter temp on heated bed, I used 120C.
Second, warping can be stopped by using brim, I used 5-15mm depends on model.
Third, you can stop wapring using...

I have successfully tested ABS from 3 different manufacturers at 280C - same result.

3) Vase 185mm height, 1 perimeter, spiral mode, flow 200%, 280C, 60mm/s speed...

At this moment I have few succeeded prints (big models up to 150mm in diameter and up to 180mm in height) at 280C without any enclosure and for some models with enabled extrusion cooling fan(!!!):
...

Hello All.
I spent a couple of weeks, even months in a vain attempt to print anything bigger than 40mm cube from ABS plastic.
There are no problems with printing small models, but with large...

i have i3 and don't want to upgrade it to i3v.
there is no sense in this upgrade, as it is not cheap, but the quality of the print will not be much better, u can get slightly better quality with...

Voronoi deer by 3dizingof.com

Printed in PLA on my i3 8" Makerfarm in 17h head + 4h horns


39633964

3888skull

ABS, 0.2layer, KISSlicer, 280C.

38863887

I have a problem with leveling on latest branch on my makerfarm i3 8".

SETTINGS:
--------------------

// set the rectangle in which to probe
#define LEFT_PROBE_BED_POSITION 50
...