Thank You, I actually use Notepad++ for exactly that reason :), I;m going to give it a shot and see how it goes...
Type: Posts; User: ctcwhexdx
Thank You, I actually use Notepad++ for exactly that reason :), I;m going to give it a shot and see how it goes...
Hello,
A few weeks ago I upgraded my 8" I3V to a 10" Pegasus, and so far it's been going fairly ok(with the exception of a stepper and a lcd going bad). I have the older stepper motors from when...
Something else to look at in the configuration.h, right about that line it says :
//If defined, the Probe servo will be turned on only during movement and then turned off to avoid jerk
//The value...
I just wanted to say Thank You for doing this, i've been going crazy trying to get my setup running until now!!!
Not to confuse myself more than I already am, but take a look at this thread...
Go into configuration.h around line 455 or so, do you have #define PROBE_SERVO_DEACTIVATION_DELAY 300 enabled, if so put a // in front of it and see if it compiles.
I just ran into the same...
I'm using complete code bases, I learned the hard way years ago not to mix old configs with new ones. What get's me with this is usually you cannot use the sdcard functions at all, with this one I...
I forgot to add that the pin assignments are the same....
Thank You for helping me with this, i've gone cross-eyed at this point!! I did do a diff against the old and the new pins.h file, there are 300 more lines in the new pins.h file vs the old one. In...
I might of spoke to soon, on one hand the auto-bed leveling is working great!! On the other hand I have run into something that has me stumped. I have a ramps 1.4 setup with the...
That was it, it's compiling now without any errors. Thank You!
Good Morning,,
I am running into an issue when I try to follow the first post for setting this up, I downloaded the most recent firmware from the link on the first post, as mine is older, made all...