Yeah? Where are you going?
I guess I better be careful this next week.
Type: Posts; User: Zulfe
Yeah? Where are you going?
I guess I better be careful this next week.
Printbus, you are a goddamn genius.
I fixed the pin conflicts which Colin had accidentally left (as did I when I modified the code) and it works like a charm. One click every 5 or so seconds...
You're right. My nozzle heater is connected to D10. I had them confused. My D08 has melted down due to either overcurrenting or loose wires (probably the latter). I'm connected to D09 as a...
My heater cartridge is connected to D08. I just talked to my father (an electrician) and he said that there's an issue with whatever switches it on and off. When I turn the bed off in Pronterface,...
Are you sure that's correct? I configured mine according to the Makerfarm site which says:
I attempted to fix it myself by editing some code in the pins.h file. I found the motherboard 33 pin setup and changed the bed to 9. When I hooked everything up, uploading the firmware, and ran it...
Just received my heat bed relay. I connected one wire of the bed to J2 and ground from my PSU to J2. I connected the other wire to the OUT terminal on J1 and 12v to the IN on J1. My bed still isn't...