Mjolinor,
First off I want to thank you for your kind help and support. It is really appreciated.
The new motherboard arrived today, i installed it and it works. I am doing the first "test print"...
Type: Posts; User: Don
Mjolinor,
First off I want to thank you for your kind help and support. It is really appreciated.
The new motherboard arrived today, i installed it and it works. I am doing the first "test print"...
Make sure you get the "old" version of the Motherboard schematic. The old version has the thermocouple wires SCREWED to the hot end. The new version shows the "little bulb" type thermocouples. This...
OK, Pin to pin is zero volts. Each pin to ground is zero volts. Not connected to anything.
I'll Google the schematic.
It's hard to see in the pictures but in the top left corner is where the temperature sensor wires connect. These wires are attached to the hot end with a screw, each attachment screw has two wires...
OK, here's the pictures.
56915692 Don
No luck on that "fix" tried it all, no luck.
I did find a USA based company that will help. I described the problem and was told it is a bad motherboard. I ordered a new one.
I found out that the temp sensors are built into the motherboard.
A little follow up....
I got brave and unplugged all the connections from the mother board except the "power in" and the LCD display. It still beeped and said "over heated".
I have to think it's a...
Hi,
I'm new to 3D printing and bought a CTC dual clone off eBay and am having trouble(s). The seller is useless and will not help so I'm on my own.
It worked very good for two days.
Then the #2...