Outside in.
Type: Posts; User: BLKKROW
Outside in.
I have tested your settings and the cylinder is not 100% perfect it is really close to what it was previously. The inside layer change blobs are a lot better but on the oustide you can see the same...
What I print will not work in vase mode. I will just have to play around with it, maybe try the Z antibacklash mod or change the firmware to increase Z acceleration.
That is exactly what I am referring too, the side where the layer change occurs it leaves behind that weird trail.
I have tried a lot of settings in S3D to get it to print well. Which it does, it...
So I have changed the feed rate to 15 mm/s and I am still receiving the same artifacts. Could it be the Z axis is moving too slow?
I will certainly change it!
I have tried speeding up retraction, why would you want to slow it down? I am just curious and wanting to learn?
Also, I have noticed when changing from one layer to another it takes a while for...
I apologize this is with PLA at 210*
So I have a Prusa IV3 12" with Rumba running the stock firmware from the installation guide. I have upgraded the X and Y idler to use the gear instead of the bearings. I also have a cooling fan (Not...