I think I understand now. So you sort of "calibrate" the numbers for the filament. In your first example you use PLA on 4. Once you get that dialed in, it should be as easy as moving numbers for...
Type: Posts; User: athlon2k2
I think I understand now. So you sort of "calibrate" the numbers for the filament. In your first example you use PLA on 4. Once you get that dialed in, it should be as easy as moving numbers for...
Thanks wirlybird. Is it safe to assume that the numbers are more of a course adjustment and the set screw is a fine adjustment? In my predicament the set screw was too loose so I am compensating by...
Well I ran through the normal leveling process and I found that the Z-axis was off which explains having more issues on the right side of the print. I tried several times to print in PLA (the...
Well I ran through the normal leveling process and I found that the Z-axis was off which explains having more issues on the right side of the print. I tried several times to print in PLA (the...
Thanks for the replies. I will try the suggested after I get my printer functioning again. It appears after trying to print some NinjaFlex I can no longer get successful prints with PLA. I'm assuming...
I should also add my print speeds from this print using Cura. Also layer height was set to .2mm
Print speed 60 mm/s
Infill 60mm/s
Top/Bottom 20 mm/s
Travel 100mm/s
Since I've had this printer I have not been able to print good ABS prints. My PLA prints are pretty decent. I have no issues with bed adhesion, but each layer is wavy and the head is knocking of...