Hi All,
I have a FFCX and a FFC Pro which have been working fine until today, both printers have suddenly started producing varying thicknesses in the print walls as per the image that I hope...
Type: Posts; User: Entity
Hi All,
I have a FFCX and a FFC Pro which have been working fine until today, both printers have suddenly started producing varying thicknesses in the print walls as per the image that I hope...
Hmmm,
Found no on board reference to turning the extra fan on, anyone else had to address this issue on the Pro Yet.
Cheers
Good question,
Well there is an additional cooling fan attached to the Creator Pro that was never on the Creator X, possibly its just a stock standard on board selection of either on or off, will...
Back,
Ok after reading and listening to others it also appears that a fair cause of the left hand side of the print being initially deformed when only a small diameter object may be due to this...
Well I am getting closer,
I know not all of my makerware settings are correct, however the print worked with the only defect being on left hand side of object were object is only 1 mm wide, it...
Well I guess I better figure out how to turn on that cooling fan mounted to the extruders on the FFCPro, and study makerware.
The particular model prints perfect if split it, as therefore have...
Tried makerware but soooo many settings in there that I don't yet understand, lowered bed temp to 105 and that helped marginally.
Start of prints looks like a bowl so like you suggested, think...
Hello All,
Every print on either machine of the using the same model is going pear shape for the first 1cm of the model as per images, but the remainder of the print is fine. unsure about RepG...
Jimc,
Whats a good open source slicer program for preparing your models for printing, I tried slicr3 but it wont export 3xg files in a firmware version that my creator pro recognises.
Cheers
Gday,
I do 90% of my print designs using Cinema 4D, took awhile to get my head around it, It`s great for fine detail adjustments and you get set desired polygon counts as high as you want...
Hi All,
Had been just using RepG, but now using slicr3 and makerbot as well as all have different attributes I find useful, hence have the question on makerbot settings.
What settings should...
Well,
Just tried a different print after changing extruder selection to hold, and didn't have the issue I had with that print earlier, so sshall try the print a posted image of tomorrow as its now...
Ok trying a print now,
Been so long, what feed and travel do you generally use for ABS.
I was running 70 & 80 previously but now with new motherboard etc have slowed it right down for this...
ok, never had to check that before but it does now have new motherboard and firmware so probably lots of settings pear shaped, should ditto printing be on or off ??
And thankd
Hi All,
Well got my FFCX working again but the print has developed a weird seam just up one side, is this a bed levelling issue ?
7074 Any suggestions ??
Cheers
Have since found out that the 1025 is actually a safety code feedback apparently.
When disconnect heatbed code disappears yet new bed and wiring so I have absolutely no idea, whats going wrong...
Hi Again,
Well finally got PC to connect to printer, LCD still says platform temp read failing, monitor mode says temp N/A and RepG displays the following :
7007
Please Help
Hi All,
My creator X burnt out the HPB connector ( common issue ), so replaced board and still temperature reads failing, monitor mode reads extruder temps but heatbed N/A.
Advised by...