My origin, 0,0, is at the left front.
Type: Posts; User: Bob
My origin, 0,0, is at the left front.
Apparently I don't understand the topology map or I have something else really wrong.
In the map above I read that the back left, -0.73591, is low and the right front, 1.25075 is high. Is that a...
Sorry for the delay in answers. I run a home business, machining, and I have jobs to complete. I'll try to do better tomorrow.
BTW, I changed from 3 point leveling to 4.
I see my bed isn't very level.
ENDING:G29 n5 T V4
Roxy's Enhanced G29 Auto_Bed_Leveling Code V1.81:
Full support at http://3dprintboard.com
Bed x: 2.00 y: 1.00 z: 11.53
Bed x: 45.00 y: 1.00 z:...
Here you go. Looks good to me, but what do I know!
>>>m48
SENDING:M48 "Loose"
M48 Z-Probe Repeatability test. Version 2.00
Full support at: http://3dprintboard.com/forum.php
Mean: 17.065334...
Hello all.
Well, I'm getting very frustrated. Hope someone can help me.
Here's my setup.
Prusa Mendal printer.
Arduino>BeckDac firmware.
Auto bed leveling.
Bed is 1/2" aluminum tooling...
Thanks Roxie for your help. I have the code the same now. I will try to load it up later today and see what it does.
Thanks again. I REALLY do appreciate it. Other forums just don't seem to want to...
Hello all. I've been printing, off and on, for a couple of years. However, my prints were hit and miss. Sometimes perfect, sometimes not so much. Lot's of time and filament wasted.
I am now in the...