Search:

Apparently, green or blue lasers give better results.

Not really, I've been trying to scan really small stuff, and for that, I changed the lasers on my Atlas 3D from the original ones to focusing...

The Cyclop scanner is closer in functionality to the Atlas 3D, than the David Laser scanner (aka Starter Kit). That uses a calibration panel with point references behind the model during the scan. A...

I also have an Atlas 3D scanner. This a DIY Laser scanner that I bought and used with pretty decent results. It's not in the same class as the Einscan-S, and it does require some post scan work to...

As promised, here are the STL's.


They've been reduced to about 300-400K triangles, which is more than enough to preserve the details. These STL's are in the 20-30MB range, so I'm posting them...

All these are turntable scans. Most of them require multiple passes to get as much of the surface scanned, but the software does a very good job of aligning the scans (better than what I can do...

Some are straight up scans, others are partially processed. On most of them, the bottom 1-2mm weres cut off to make it flat.

Hulkbuster the bottom of the base was cut off to make it flat, and of...

I'm not sure how legal that would be, considering all these are copyrighted material. There will be other things I'll post, but I'm not sure I want to piss off the Disney Company.

Here are a...

Below are some of my scans. A lot of them are of the Disney Infinity series figure, some of other things I found around my room.

First one up, is the model I was using to improve the sharness of...