New Activity ()
Please reload this page to view the 200+ new activity items that have been created.
-
Older Activity
-
Today, 01:30 AM
Sounds very much like the nozzle is slightly too far from the bed.
Suggest.....Print a 50mm square just one layer thick and adjust the 'Z' offset...
6 replies | 364 view(s)
-
Yesterday, 06:26 PM
Ok, so cleaning filament is just that. When you remove the pla you heat the nozzle with the nozzle way above the bed and you extrude 200 or 300 mm. ...
6 replies | 364 view(s)
-
Yesterday, 05:25 PM
Good questions and something I have never heard of. Give me a second to respond...When printing starts it lays down a nice even line, makes a turn,...
6 replies | 364 view(s)
-
Yesterday, 04:19 PM
and what happens when the print starts.. filament balls up or just does not stick? Have you run cleaning filament through your hot end after the PLA...
6 replies | 364 view(s)
-
Yesterday, 02:22 PM
I have tried with both printers. On the Aquila I just follow the regular leveling process, I.E. set the bed height so at each corner I can just start...
6 replies | 364 view(s)
-
Yesterday, 01:22 PM
PETG sticks to anything if the starting Z axis offset (gap between nozzle and bed when it is at Z0 is within the proper parameters. I use to print...
6 replies | 364 view(s)
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help