Activity Stream
-
Older Activity
-
Today, 07:04 PMclkwrkbrd replied to a thread New Ender 3 Neo: stops extruding filament halfway through in Tips, Tricks and Tech HelpThank you! That's helpful.My extruder is brand new, so I'm not sure if a clog is possible, but I'll look/clean. Also, just looking at the dip in the...2 replies | 112 view(s)
-
Today, 02:12 PMBikeracer2020 replied to a thread New Ender 3 Neo: stops extruding filament halfway through in Tips, Tricks and Tech HelpCould be...... Extruder gears clogged with filament from grinding the filament. Extruder tension needs increasing but not if it's grinding...2 replies | 112 view(s)
-
Today, 02:02 PMBikeracer2020 replied to a thread Extruder not feeding during print, but purge works fine in Tips, Tricks and Tech HelpGlad you got it sorted.7 replies | 804 view(s)
-
Today, 01:58 PMStargazed replied to a thread Extruder not feeding during print, but purge works fine in Tips, Tricks and Tech HelpI found the problem. The extruder ribbon cable was broken, how this happened I have no clue. It could be just wear and tear after two years of...7 replies | 804 view(s)
-
Today, 12:39 PMclkwrkbrd started a thread New Ender 3 Neo: stops extruding filament halfway through in Tips, Tricks and Tech HelpHi, everyone! I'm running into some challenges getting my Ender 3 v2 Neo up and running. I've never successfully completed a whole print. What's...2 replies | 112 view(s)
-
Today, 06:49 AMHello. I am new to 3D printing. I'm going to try to print out a hull for a scala model boat but I don't think it will turn out well. I have a...0 replies | 154 view(s)
-
Today, 04:18 AMBikeracer2020 replied to a thread Extruder not feeding during print, but purge works fine in Tips, Tricks and Tech HelpThis is a guess...... Sounds like the G-code extrude command 'e' is missing in the start G-code. When you reinstalled Cura did you copy the...7 replies | 804 view(s)
-
Today, 02:50 AMStargazed replied to a thread Extruder not feeding during print, but purge works fine in Tips, Tricks and Tech HelpThe feeder motor is not trying to move during the print but when I purge it works 100% so there has to be something else7 replies | 804 view(s)
-
Today, 01:57 AMI think I'll have to look at a way of securing the edges that doesn't encroach too much on to the build area. My usual bed temp is 95 degrees, so...2 replies | 317 view(s)
-
Yesterday, 08:50 PMyt1300 replied to a thread Anycubic Vyper is suddenly extremely stringy in Tips, Tricks and Tech HelpHi, nothing seems to be wrong with my hot end. I'm not quite sure what you are suggesting I need to do2 replies | 267 view(s)
-
Yesterday, 08:38 PMRoberts_Clif replied to a thread Anycubic Vyper is suddenly extremely stringy in Tips, Tricks and Tech HelpBelow is a tutorial on how to fix, https://www.youtube.com/watch?v=FqHXkmRoLXA2 replies | 267 view(s)
Extruder not feeding during print,...
Today, 02:02 PM in Tips, Tricks and Tech Help