Activity Stream
-
Older Activity
-
Today, 10:58 AMThe Ender 3 is simpler to use and, if I'm not mistaken, cheaper. It all depends on what you plan to do. I started with the Ender 3 but switched to...2 replies | 1985 view(s)
-
Today, 10:44 AMFirst, check the slicing settings in Makerbot Desktop to ensure that both extruders are configured correctly for dual extrusion printing. Pay...1 replies | 7133 view(s)
-
Today, 08:40 AMhello Use 210C for Nozzle and 55C for Bed temp with PLA+. ALWAYS use a raft1 replies | 319 view(s)
-
Today, 01:35 AMThe Qidi X-CF pro is enclosed and I never open the door until everything has cooled down to ambient temperature. Magnetic grip seems the same hot...4 replies | 466 view(s)
-
Yesterday, 09:26 PMRoberts_Clif replied to a thread Anycubic Vyper is suddenly extremely stringy in Tips, Tricks and Tech HelpWhen I have similar problems you are describing, I find that the PTFE tubing has deformed and needs to be replaced. Pictures attached. Thought...3 replies | 389 view(s)
-
Yesterday, 09:18 PMI have been getting away with Printing ABS with a Bed temp of 96C and Print temp of 232C by placing the 3D Printer in a enclosure. This keeps...4 replies | 466 view(s)
-
Yesterday, 07:04 PMclkwrkbrd replied to a thread New Ender 3 Neo: stops extruding filament halfway through in Tips, Tricks and Tech HelpThank you! That's helpful.My extruder is brand new, so I'm not sure if a clog is possible, but I'll look/clean. Also, just looking at the dip in the...2 replies | 193 view(s)
Extruder not feeding during print,...
Yesterday, 02:02 PM in Tips, Tricks and Tech Help