Activity Stream
-
Older Activity
-
Today, 01:35 AMThe Qidi X-CF pro is enclosed and I never open the door until everything has cooled down to ambient temperature. Magnetic grip seems the same hot...4 replies | 407 view(s)
-
Yesterday, 09:26 PMRoberts_Clif replied to a thread Anycubic Vyper is suddenly extremely stringy in Tips, Tricks and Tech HelpWhen I have similar problems you are describing, I find that the PTFE tubing has deformed and needs to be replaced. Pictures attached. Thought...3 replies | 340 view(s)
-
Yesterday, 09:18 PMI have been getting away with Printing ABS with a Bed temp of 96C and Print temp of 232C by placing the 3D Printer in a enclosure. This keeps...4 replies | 407 view(s)
-
Yesterday, 07:04 PMclkwrkbrd replied to a thread New Ender 3 Neo: stops extruding filament halfway through in Tips, Tricks and Tech HelpThank you! That's helpful.My extruder is brand new, so I'm not sure if a clog is possible, but I'll look/clean. Also, just looking at the dip in the...2 replies | 167 view(s)
-
Yesterday, 02:12 PMBikeracer2020 replied to a thread New Ender 3 Neo: stops extruding filament halfway through in Tips, Tricks and Tech HelpCould be...... Extruder gears clogged with filament from grinding the filament. Extruder tension needs increasing but not if it's grinding...2 replies | 167 view(s)
-
Yesterday, 02:02 PMBikeracer2020 replied to a thread Extruder not feeding during print, but purge works fine in Tips, Tricks and Tech HelpGlad you got it sorted.7 replies | 841 view(s)
-
Yesterday, 01:58 PMStargazed replied to a thread Extruder not feeding during print, but purge works fine in Tips, Tricks and Tech HelpI found the problem. The extruder ribbon cable was broken, how this happened I have no clue. It could be just wear and tear after two years of...7 replies | 841 view(s)
-
Yesterday, 12:39 PMclkwrkbrd started a thread New Ender 3 Neo: stops extruding filament halfway through in Tips, Tricks and Tech HelpHi, everyone! I'm running into some challenges getting my Ender 3 v2 Neo up and running. I've never successfully completed a whole print. What's...2 replies | 167 view(s)
-
Yesterday, 06:49 AMHello. I am new to 3D printing. I'm going to try to print out a hull for a scala model boat but I don't think it will turn out well. I have a...0 replies | 256 view(s)
Extruder not feeding during print,...
Yesterday, 02:02 PM in Tips, Tricks and Tech Help