Close



Dig deeper, search our News website




Search:

Tag: petg

Search: Search took 0.00 seconds.

  1. Looking for PETG Tip

    Started by qwiktune, 09-01-2019 04:01 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 1,423
    Last Post: 11-02-2019 12:48 PM
    by qwiktune  Go to last post
  2. PETG filament not printing well

    Started by lukuky64, 07-28-2019 10:16 PM
    • Replies: 2
    • Views: 385
    Last Post: 07-31-2019 11:55 PM
    by aidenolsen  Go to last post
    • Replies: 0
    • Views: 390
    Last Post: 07-27-2019 01:22 AM
    by lukuky64  Go to last post
    • Replies: 3
    • Views: 2,856
    Last Post: 11-30-2016 11:13 AM
    by makeshaper  Go to last post
  3. Sticks too well

    Started by mrehmus, 11-16-2016 10:49 AM
    2 Pages
    1 2
    petg, qidi x-one
    • Replies: 16
    • Views: 8,574
    Last Post: 11-20-2016 01:25 PM
    by Todd-67  Go to last post
  4. Problems with PETG... very frustrated!

    Started by mono989, 10-25-2016 01:43 PM
    • Replies: 3
    • Views: 2,510
    Last Post: 11-20-2016 07:00 AM
    by curious aardvark  Go to last post
  5. Canada, US InkSmith Filaments | 16 Varieties

    Started by Ransom, 05-25-2016 02:09 PM
    abs, canada, filament, petg, pla
    • Replies: 0
    • Views: 1,456
    Last Post: 05-25-2016 02:09 PM
    by Ransom  Go to last post
  6. Are small PETG gears tough enough for setscrews to fasten to shaft?

    Started by TimM, 01-20-2016 09:15 AM
    2 Pages
    1 2
    gear, petg, setscrew
    • Replies: 10
    • Views: 4,939
    Last Post: 01-21-2016 01:37 PM
    by TimM  Go to last post
  7. Finally have a HPB on a Makerbot 5th Gen

    Started by Lanyx, 01-12-2016 11:22 AM
    • Replies: 1
    • Views: 1,951
    Last Post: 01-12-2016 05:32 PM
    by ServiceXp  Go to last post
Results 1 to 9 of 9