Anyone printing PET on a FF

[3DPBuser]

Any of the varieties of PET.

And I guess a Dreamer could not be included in this, since I believe that the carriage might melt at the higher temps.

[curious aardvark]

not yet - but i do have plenty samples of it.
Don't envisage any problems :-)

[jimc]

You dont need higher temps for pet. Pet runs at the same temp as abs so if your orinter is up to the abs task then its good to go for pet

[3DPBuser]

Ok it would be great to see some prints from some people. The nice thing about FF is that for a MB spinoff group, it seems big enough that niche things like PET should have some traction.

[curious aardvark]

traction ?

[Stigern]

I think hes referring to adhesion to the bed?