Close



Results 1 to 3 of 3
  1. #1
    3DPrintBoardPro Member car3less's Avatar
    Join Date
    Oct 2014
    Location
    Bucuresti
    Posts
    109
    Follow car3less On Twitter Add car3less on Facebook Add car3less on Shapeways

    Unhappy bronzeFill filament

    Did anyone try bronzeFill filament from ColorFabb with Up! Plus 2?
    I tried woodFill and worked, but I was told I should't try the other one because the extruder would be clogged. Any experience to share?
    Printare 3D Bucuresti

    Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke

  2. #2
    Super Moderator JohnA136's Avatar
    Join Date
    Oct 2013
    Location
    Jersey Shore
    Posts
    548
    I was told that for some of the exotics, you really need a large bore extruder? You can email or contact Matt from printedsolid.com and ask him. He is our local ColorFabb distributer and has extensive knowledge on these specialty filaments re: temps, extruders, finishing.

  3. #3
    3DPrintBoardPro Member car3less's Avatar
    Join Date
    Oct 2014
    Location
    Bucuresti
    Posts
    109
    Follow car3less On Twitter Add car3less on Facebook Add car3less on Shapeways
    ok. thanks!
    Printare 3D Bucuresti

    Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •