Adventurer 3 Pro vs Adventurer 3 lite

[kevsbox]

Hi

I have just switched from a Adventurer 3 lite to the Adventurer 3 Pro and in general it is a very nice bit of kit with one exception.

The lite version used flex build plates which never needed adhesive for the prints to stick, were easy to clean and I had 4 so switching in and out was easy.


lite.jpg


The pro uses the Glass Build Plate which requires adhesive to stick, is hard to clean and difficult to get out.


pro.jpg


So my question is are these inter-changable, can I put the non pro system into the pro printer?

Cheers


Kev

[airscapes]

If it fits, why not? Lots of aftermarket systems like buildtek and others..