Hello everyone. I am new to 3d printing, and I am trying to get my Elegoo Neptune 4 PLUS dialed in. I've had some struggles out of the box with bed adhesion with both PLA and PETG, and crazy stringiness, layer adhesion and boogers with PETG which is probably expected for a noob. Anyhow, I installed OpenNept4une last week and have been maticulously going through all of the setup and adjustments in the wiki over there. I printed a scraper I found over on Printables to help get things off the bed, and I'd like your comments about the print quality and what I should look at tweaking to make it better.


Using Orca slicer, printed in dried PETG (10% humidity), 4mm nozzle, 235c, layer height .2mm, flow ratio 1.08, PA .124, retraction length 5mm, z-hop .5mm. 3 walls, 3 top layers, 4 bottom, 10% gyroid infill. 20mm first layer speed, 60mm outer wall speed, 200mm inner wall speed.


Stringing on this was much less than I've had in the past, but it might just be the model. I think the top of the print looks like crap. What do you all think? What should I look at tweaking to get it even better?
Thanks in advance for the help!

Bottom.jpgSide.jpgTop1.jpgTop2.jpgTop3.jpg