Bad Neptune 4 Max Layering Problem;; Help Please

[galaxybeing]

My Neptune 4 Max has been pretty nice in the 6 months I've had i (new). But there's a big problem, which is depicted in the attached photos of a film developing tank I drew up.. Photo 1 shows the approx position it was printed on the bed. Photo 2 shows the layer problem I'm having on the right half. The tank is about 12 inches wide and 10 inches tall, BTW. Photo 3 shows the problem as it appears on the back side of the tank. This tank is supposed to hold water, but it leaks on the right side. I am quite mechanically able to follow advise and instructions, but don't know what maladjustment to look for. As an aside, I notice the the bed rollers on the underside of the bed have no apparent way to get to the adjustments, aside from disassembling the machine quite a bit. But what is the problem I'm dealing with now? Thank you.

[Roberts_Clif]

ELEGOO NEPTUNE 4 PRO: How to adjust the eccentric wheel?


https://www.youtube.com/watch?v=PdIiIy7f1Jk


Hope this helps